This is a more advanced solution that involves downloading and installing firmware onto your device, so it's important to follow instructions carefully and proceed with caution. If that doesn't work, you may need to try flashing the device with new firmware using a tool like Odin. This will force the device to shut down completely and may help to resolve any software issues causing the booting problem. One possible solution is to try a soft reset by holding down the power button for at least 10 seconds. If your Galaxy Tab 2 10.1 is getting stuck on the "SAMSUNG" logo and you have already attempted a hard reset without success, there are a few other things you can try to fix the issue. 3 minutes worked for me but some suggest a few hours. You may like to leave the battery disconnected for a longer time to allow full discharge of the electronics. I have lost all my files in the process but I have back-ups so fortunately no loss for me. Lots of people asking how to fix and I spent hours looking for a solution, most involving accessing the ASR recovery which I could not do or rooting/reloading firmware which I was reluctant to attempt. This boot loop problem is very common it seems. 2 minutes later it was wiped, and started normally. I then started the ASR again and selected Wipe Data/Factory reset. I tried clearing the cache but no change. NOTE the tablet MUST be running on battery only- charger disconnected However, this time, I could access the ASR (see point 2 above) successfully. I tried to start the tablet but was still stuck in the boot loop cycle. **SOLUTION** I opened the case and disconnected the power connector to the battery for about 3 minutes. tar files which were quite foreign to me. I read lots about reloading firmware using ODIN and PIT and. It made no difference if it was charging or on battery. The tablet is supposed to boot into the recovery menu but for me it just continued to the animated Samsung logo and then cycled again like before. This is usually done by holding the power button and volume down button (Vol down is the one closest to the power button) simultaneously and releasing the power button when the white Samsung Galaxy Tab 2 10.1 logo comes up. Battery was charged to 100% the entire time.Ģ) I could not enter the ASR (Android System Recovery) mode to try the other suggested options of clearing the cache or wiping the tablet back to factory settings. The tablet can not be forced off (holding power button down) unless the charger is connected. It will continue this cycle continuously. Solved for a Samsung Galaxy Tab 2 10.1 (GT-P5110) stuck in boot loop AND unable to enter ASR recovery mode.ġ) Boots to white Samsung Tab 2 screen, and then through to coloured animated Samsung logo where it then gets stuck and commences booting again. You should attempt firmware flash first if you need to keep user data that's on the device then do factory reset as that is the only option after that. It can also be caused by corrupt firmware too. Stuck on animated Logo usually means the partition on the device that is used for user data is corrupt and needs to be wiped by doing the factory reset method.Stuck on white Samsung Logo usually means device is soft-bricked (Recoverable using firmware flash), caused by a bad battery or insufficiently charged battery.If this still doesn't solve the problem then you will need to restore firmware using Samsung Kies (ODIN downloader flash method works too). Wait for this to complete and reboot tablet. Use volume keys to navigate the menu and the power / home key to select the highlighted option.ĭo wipe data / factory reset. Once you get into a recovery menu which usually release all keys. When Samsung logo appears stop holding the power button but continue holding the other buttons. Hold power button + volume up + home button until Samsung logo appears. If firmware flash does not help then a factory reset must be done to get the device working again.ĭisclaimer: I am not responsible for any data lost from your device when you follow the steps below: If you need to keep the user data (photos and etc) try flashing latest android system firmware first by following instructions provided in link below: Usually when the Tablet is stuck on the animated Samsung Logo you may need to do either a factory reset or reflashing firmware on tablet (same android version or newer). Try leaving it on charge for half an hour if that does not work you may need to do a factory reset or reload the software on the tablet in order to get it working again. Try holding power + volume down for 10-15 seconds and attempt to turn it on and or charge it again. Before reading below there is a common issue with these tablets where they do not turn on properly or get stuck on the charging battery icon.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |